Strilich Cut-to-Length Line
Capacity: 48" x 0.040" - 0.190" Mild Steel
Shear Strength: 50,000 PSI
Yield Strength: 50,000 PSI
Weight Capacity: 25,000 lbs.
Line Speed: 0 - 125 FPM
Electrical Supply: 480 V/3 PH/60 Hz
Line Direction: Right to Left
Consisting of the following:
-Single Mandrel Uncoiler:
Maximum Coil Width Capacity: 48"
Maximum Coil Weight Capacity: 25,000 lbs.
72" Maximum Coil O.D.
18.50" - 24.50" Hydraulic Three Arm Mandrel Expansion Range.
Heavy Steel Cover leaves with tapered nose for easy coil loading.
Wedge type expansion provides coil stability and constant hydraulic
loading through the entire expansion range.
Designed for accessibility and easy maintenance.
Heavy Duty Construction.
Hydraulic powered urethane covered overarm snubber roll with banding groove.
Hydraulic feedup threading drive
Hydraulic slide base +/- 6" horizontal travel with manual control for
Air Drag Brake, water cooled.
-Hydraulic Z-Type Peeler Table: 8' Long
Maximum Strip Width: 48"
Heavy Duty fabricated structural steel construction.
1" thick beveled nose reinforced peeler plate.
Heavy duty hydraulic table positioning cylinders.
Cylinders piped to valve manifold.
Free-standing operator control console.
-Adjustable Entry Guide:
Maximum Material Width: 48"
Heavy duty welded structural steel frame.
Four sided hardened guide plates are mounted on heavy duty machined
steel blocks with acme nuts.
Guides are adjusted off center line through left and right hand
acme screws via handwheel.
Makes the initial centerline threading of the lead edge into the
straightener pinch rolls easier.
-Combination Coil Breaker and Straightener on Common Base:
Maximum Strip Width Capacity: 48"
Material Thickness Capacity: 0.040" - 0.190"
Entry 6" Dia. Powered Pinch Rolls, Air Cylinder Loaded
5 Roll Coil Breaker, 2 over 3, with 5.5" Dia. Rolls
7 Roll Straightener, 3 over 4, with 4" Dia. Rolls
Exit 6" Dia. Powered Pinch Rolls, Manual Jackscrew Adjustment
Common Variable Speed AC Vector Drive geared for 125 FPM Max. Roll Speed
All Work Rolls and Pinch Rolls are chain driven.
-Flying Cutoff System:
Hydraulic Cutoff Die complete with D2 HC-HC cutoff blades.
Rack and Pinion Die Accelerator.
Indramat Closed Loop DC Servo Drive and Control.
Cutoff Die mounted on precision ball type slide ways.
Roller Sheet Support Tables supplied.
-Main Operator's Control Station and Electrical Cabinets:
Meter which indicates machine speed in ft/Min.
Device which will permit operator to preset the number of parts
to be cut and which will then stop the machine when preset
number of parts has been obtained.
Electrical Drive Enclosures - (2)
Main Operators Control Station with Remote Station
Uncoiler Drag Brake Heat Exchanger Unit
Entry/Exit Hydraulic Pumping Units
Shear Head Hydraulic Pumping Unit
-Removed and in Storage: Toledo, OH.