24" x 4.125" x 22,000# Ruesch Slitting Line

Brand
RUESCH

Model

Stock #
2054

Condition
Used

Year
2000

Location
Toledo, Ohio
United States

Specifications

Max Width of Workpiece 24 inches
Max Thickness of Workpiece (in.) 0.040 inches

Equipped With

Material:           Mild Steel, CR, AL, Stainless, Non-Ferrous
Material Width:     24" (26" untrimmed)
Thickness Range:    0.005" - 0.040"
Line Speed:         1000 FPM
Line Direction:     Right to Left
 
Consisting of the following:
 
-Entry Coil Car:
  Low Profile Design
  Narrow Coil Stabilizers
  Self Contained Hydraulics
  Pendant Control
 
-Uncoiler:
  Hydraulic Expansion
  4 Segment Mandrel
  16" - 20" Coil I.D. Range
  Maximum Coil O.D.:  63"
  Sliding Base
  50 HP DC Motor, 500/2000 RPM, 500V
  Powered Holddown Roll
    Rubber Covered Roll with Banding Slot
  Paper Rewinder
 
-Driven Pinch Roll Unit:
  18" Diameter Rolls
  Exit Catenary Rolls
  15 HP DC Motor, 1150/2000 RPM
 
-Ultrasonic Detector:

-Precision Slitter Heads:
  Model #146
  (2) Injector Heads
  Entry Catenary Rolls
  Entry Side Guides
  4.125" Dia. Arbors
  Steel Stripper Ring Assembly
  Exit Passline Rolls
  Exit Catenary Rolls
  60 HP DC Motor, 1500/2000 RPM, 500V
 
-Injector Head Shuttle Base:
 
-Looping Pit Threading Table:

-Ultrasonic Detector:
 
-Scrap Baller:
 
-Tension Stand:
  Combination Drag and Roll Type
  Entry Catenary Rolls
  Entry Separator Tooling Bar
  Entry Passline Roll
  Entry Wiper
  Drag Wipe Section with Air Bladder
  3M Tension Rolls
    Each Roll Driven by 30 HP DC Motor
  Passline is adjustable by Laser guide. Tensioners adjust vertically
    as Coil O.D. increases on Recoiler to maintain a constant Passline.
  Threading Table to Recoiler
 
-Recoiler:
  16" Dia. Drum
  Manual Clamp & Expansion
  Max. Coil O.D.:  63"
  Hydraulic Pushoff
  Overarm Separator Assembly
   (Attached to Tension Stand)
  Coil Clamping Arm
  60 HP DC Motor, 500/2000 RPM, 500V
 
-Exit Coil Car:
  Low Profile Design
  Narrow Coil Stabilizers
  Self Contained Hydraulics
  Pendant Control
 
-Paper Unwinder:
 
-Slitter Tooling:
  (2) Sets of Shimless Tooling
 
-Main Operators Control Panel:
 
-Hydraulic Power Unit:
 
-Removed and in Storage
 
Note: Original Line cost was $3,000,000. in 2000.
      Line only was in production for short time.